First of all thanks to Sim and Quack for the response ( sorry, I frittered a little as I 'm a newbie here) .Hence I 'm editing it and making it more clariion oriented . Secondly, I 've a question ... If one of the HBAs in the server is not visible to the storage even if navisphere , powerpath and Navi Cli 're installed what could be the reason ?
Would appreciate if some one can elaborate it .
Thanks in advance!
As a starting point have you registered at EMC Powerlink yet? There is a lot of great information there.
I would check for physcal problems between the SAN and your server (replace cabling with a known good ones, try a differet port on the switch, replace HBA as a last resort as you will have to reconfigure the HBA's address). I had a similar issue with a CX3-10 last week that turned out to be a bad SFP on the SAN switch.
This was working at one point right? or is this a new setup?
